|Body style||Six-light all-steel saloon|
|Engine||4-cylinder Inline 1185 cc|
|Transmission||Daimler fluid flywheel and Wilson four-speed preselective self-changing gearbox|
|Wheelbase||(8'1½") 97.5 in (2,480 mm) and (8'3") 99 in (2,500 mm) Track (4'0") 48 in (1,200 mm)|
|Kerb weight||18 cwt|
The BSA Ten is a small car manufactured for BSA Cars by BSA subsidiary The Daimler Company Limited. Announced in October 1932 first deliveries were delayed until February 1933. A cheaper and less well-finished version of the Lanchester Ten with a smaller side-valve engine of BSA design. An offering to try to meet the market of the Great Depression.
One-piece pressed-steel body with sliding roof and leather upholstery, Triplex safety glass.
The crankshaft runs in two large bearings. Timing is by chain. The valves are at the side and worked by tappets acting directly on a large-diameter two-bearing camshaft. Tappets are on the near side and may be accessed for regulation. Sparking plugs are easily accessed. The vertically driven make and break and distributor is on the off side in front of the generator. Inlet and exhaust manifolds are cast together and mounted on the near side. There is an air cleaner. Petrol is delivered by pump. The electrical system is 12 volt.
Daimler fluid flywheel and Wilson four-speed preselective self-changing gearbox. The propeller shaft is open and has mechanical joints. The banjo back axle case contains spiral bevel gearing.
The frame has the popular cruciform or X channelled sectioned cross membering. The unit of engine, fluid flywheel and self changing gearbox is held at four points on rubber, the two points in front being close together and on the cross member. Half elliptical springs wide-set to prevent roll are fitted with hydraulic shock absorbers. Steering is by cam and lever. The four-wheel brakes are worked by rods.
The motoring correspondent of The Times reported reaching 57 mph (92 km/h) under favourable conditions, the makers' estimate of fuel consumption was 35 mpg at 30 mph.
- chassis with standard finish £175
- four-door six-light saloon with body by Pressed Steel Car Company £240 with leather upholstery (Lanchester Ten £315)
- four-seater open sports car with pneumatic cushions, tonneau cover, fully adjustable flat windscreen £230
New bodies for 1934 were:
- Peerless coupé £268
- Varsity saloon £265
- Tickford Foursome £290, "the now well-known Salmons body by which the head may be easily wound right back and down by turning a handle at the side. This type of coachwork has proved its reliability over several years, its is conscientioulsy made and well designed and no buyer may have qualms about it. The construction provides a car which can be run practically as an open one, as completely closed or partly open with protection at the sides."