Serpentine Belt Tensioner
A serpentine belt tensioner is designed to automatically hold a predetermined amount of tension on a drive belt while the engine is in operation. If the drive belt is loose the tensioner has failed or the wrong size belt has been installed.
The tensioner should be about half way through its travel to hold proper tension, most have a gauge stamped on them to determine belt stretch for replacement On rare occasions an engine can buck or jerk at start up and can suddenly cause a belt to jump out of place. Other problems can occur if the belt itself snaps this can be due to fatigue of the belt. The most common reason for the belt to snap is age coupled with the natural wear and tear of the belt. Before belt tensioners there was a simple adjustment bolt that was used to set the tension on the belt. The disadvantage to this set up is once the belt stretches slightly it would have to be re-adjusted. If re-adjustment is not performed the belt can create a loudscreeching noise. A belt tensioner consists of a main body, swing arm, tension spring, pulley and pulley bearing
The drive belt or serpentine belt is an essential component of your vehicle.The primary belt function is to supply power to thesteering system,water pump,air pump (if equipped) air conditioner and alternator. This belt is connected to the drive pulley of the engine to supply power. If the belt fails it will almost always render your vehicle inoperable until the drive belt is replaced. Typically most people are able to replace a serpentine belt themselves with basic automotive tools. When replacing the belt draw a diagram of the belt routing before you start to avoid confusion.
There are two different types of belts primarily; the first is a serpentine belt which tends to cross the motor several times to operate additional components. There are several names that are used to describe a serpentine belt, including Poly-V, Multi-Rib, and even a Micro-V Belt. However, all of these terms mean the exact same thing and do not change the way the belt is routed, or the type of material the belt is constructed from. A serpentine belt tends to have several V's in the belt that act as better grip for the drive pulley and components of the drive belt system
Replacing your cars serpentine belt is a relatively simple repair that can be done in a few minutes with minor tools in most cases. Always wear protective gloves and eyewear before you begin.
For regular maintenancelift the hood and do a complete visual inspection of the belt tensioner. Be sure there is no lateral movement or slow spring action. If it appears that any of these conditions exist replace the tensioner with a new unit. Replacing the tensioner before it fails is always advisable; it will prevent you from breaking down on the roadside. The drive belt is generally a component that requires maintenance. If you notice that you have to continuously change serpentine belts, you should have all of your pulleys examined for excess debris lodged inside the pulley groves. This condition will cause the tensioner to wear out prematurely.